Washboarding Cancel The title field is required!

1. Juan Villegas

   

   0 posts
   
   11/16/2016 5:11 PM

   Since some months ago I have washboarding on my fairways I use a TORO 6500, fairways are cut with different patterns every week, were roll few weeks ago but I can't see any improvement any suggestion?

   
   
   
   
2. Dan Wegener

   

   0 posts
   
   11/16/2016 6:11 PM

   At what speed do you have your tractor units set? I am sure you checked this, but in the past we have had to slow our units down (almost to a painful speed) and cut them at a 3-9 pattern. Took 3-4 mowings but worked out of it. We then adjusted the speed up slightly so that the reels would not bounce like before. 5-5.5 mph is what our speed is set at now. It worked for us.

   
   
   
   
3. Kirby Keltner

   

   0 posts
   
   11/17/2016 7:11 AM

   I've also found that if your rollers turn to hard it will cause them to bounce along. Sometimes a good grease job or new bearings can help work it out as well. But I also agree speed can be a problem.

   
   
   
   
4. Keith Lamb

   

   3 posts
   
   11/17/2016 5:11 PM

   A good circle cut would help.